Dress Your Fence
Apologies for the hiatus in posting. I needed to take a break from projects as I was preparing to move. I recently completed my trip from San Diego to Minneapolis and am now living in a house with my boyfriend so you can expect to see more fun projects soon. This project was inspired by the trend of pixelation as pattern on art and accessories. We were looking for a way to spice up the boring white fence and wanted to tie it into the house and make it visually more appealing.
The best part about this project is that the boards are mounted onto the fence with just a few nails so you can take it down and with you if you move. It’s only semi permanent. We used Dow Polystyrene Insulation Board which runs about $15 for a 8’X4′ sheet. Home Depot can cut it down for you to any size without additional charge which is convenient since I don’t normally drive a flatbed truck. This is the material after it was cut down. We ended up with the remnants of the boards too which I’m sure we can find a use for.
Prior to purchasing the materials we picked out 8 paint colors as there are 8 squares per panel. We chose exterior latex over enamel since it can have a tenancy to eat styrofoam. We stuck to exterior paint colors in an attempt to not piss off the neighbors with too wild of an installation.
From there we taped off every other square and then painted the remaining squares by hand once those were dry since we were concerned about the tape pulling up the fresh paint. We might have opted to prime the surface since it is a foil like material. This was all trial and error since we had never used this material but found that two coats was adequate with a little additional touch up. We finished off the boards with exterior polyurethane to help them weather the elements a little better.
Here is the final product.
As always, if you have any questions on how I did this or need advice on making your own, just holler! Thanks for reading and remember, today’s ideas become tomorrow realities.